![]() Tried to activate VB-cable (in Skimmer setup) - but no success - unable to route that virtual audio cable to WSJT. Simon Brown, G4ELI -Original Message- From: On Behalf Of Charly DF5VAE Sent: 23 March 2020 11:46 To: Subject: option to connect 2nd virtual cable to SDR consiole Hello, May be I have not found an already existing option to route audio in SDR console to an external prg (other than CW skimmer) via a virtual audio cable. ![]() I plan a small interface window where you can assign VACs to RXs. On Tue, at 08:21 AM, Simon Brown wrote: Hi, I have been asked for this - I know how to add it, I'll probably add this once 3.1 is released but may add as part of 3.0.23, I plan to release 3.0.22 later this week. With not more than 100mW uplink power (in shack) and 15m coax to Poty feed I manage solid FT8 copy in downlink (with 12Hz offset) Amazing stability (using SV1AVN GPSDO) and beacon lock in SDR console. Such test allows to check narrow band frequency stability and measure Tx-Rx offset in low Hz range without any Test equipment!. Question: is it possible to program a separate independant connection interface to use a virtual audio cable. I can activate VB-cable only as autio output from SDR console (instead of loudspeaker or Headphone) and use volume control to adjust level, but loose my loudspeaker/Headphone then. ![]() May be I have not found an already existing option to route audio in SDR console to an external prg (other than CW skimmer) via a virtual audio cable. To: option to connect 2nd virtual cable to SDR consiole
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |